Today i installed the plungers on both sides


Added some nice curves to the front cause i wanted the ply 3 layers deep at the plungers to keep them straight. They will probably need to have some kind of sleeve though to keep in square and reduce the wear on the ply but for now its not too bad.

I have also made some changes to the bumper that leads onto the flipper. It was just temporary before so i adjusted it to point in the right direction.

I have installed the first flipper, its a bottle opener keyring bolted to a M10ish bolt that connects to the underside flipper assembly.

The underside flipper assembly is a few bits of aluminum channel and a 240V actuator there is also a small spring used to return the flipper to its home position.

Just a few photos of the pinball table taken today.

Most of the bumpers and stuff have been cut just a few little touch up things to go.